Acoustic floor and wall systems designed and supplied by Hush Acoustics have enabled the developer of a new build apartment scheme in Surrey to deliver high quality homes which are highly insulated against the risk of flanking noise from the properties below and above.
Composition Design, the architects tasked with designing the two, three-storey apartment blocks in Cranleigh, approached the Hush Acoustics team to advise on what is a relatively common, but sometimes overlooked, issue in multi-occupancy buildings constructed using brick and block walls with timber joisted floors. The key issue was not only to ensure that the separating walls and floors were acoustically insulated to levels compliant with Approved Document E of the Building Regulations, but that measures were incorporated to prevent the potential for flanking noise to transmit between properties through the continuous blockwork.
Flanking is the issue of sound bypassing the main sound insulation materials typically integrated into walls and floors, such as acoustic plasterboard and mineral wool absorber slabs, and instead transmitting along indirect sound paths. It can be a major issue in buildings created with masonry walls and timber joisted floors because of the lightweight blocks and large voids which are characteristic of this type of construction method, particularly in walls of continuous brick and blockwork for the full height of the building.
This can result in a noise issue so significant that projects of this kind are highly susceptible to sound test failures due to flanking. Hence why the architect sought specialist guidance from Hush Acoustics at an early stage.
The Fairhaven development features two apartment blocks, which were constructed by Bohunone Building Contractors. One of the blocks incorporates three 2-bedroom flats, and the other provides four 2-bedroom flats and one 1-bedroom property, all designed and built with a traditional brick and tiled roof exterior to complement other properties in this established residential area.
To address the flanking issue, Hush Acoustics proposed a combination of floor and wall acoustic treatments. It recommended its HD1013: Hush System 2003 acoustic floor system for all the separating floors within both blocks, plus a wall lining on the inside of any masonry walls that rise up continuously to the full height of the building.
The wall lining consisted of the Hush Bar Deep resilient bars, Hush Slab 25 acoustic insulation slabs and a single layer of 15mm SoundBloc acoustic plasterboard. It was applied to all of the separating walls of the first floor properties, mostly single sided but double sided on those that are most susceptible to flanking, as well as the walls between any flats and the communal stairway.
The HD1013 acoustic floor system consists of a floating floor created using Hush Panel 28, a 19mm plasterboard plank and Hush Slab 100 absorbers within the voids between the timber joists. Hush Bar resilient bars are then attached to the joists to provide acoustic separation, to which two layers of plasterboard are then screwed to form the ceilings – one being a layer of 15mm Fireline and the other a 12.5mm SoundBloc.
Both the wall and floor acoustic systems were sealed at the perimeters to further prevent flanking noise.
Once approved by the architect, the systems were installed by the building contractor under supervision from Hush Acoustics to ensure all the components and materials were fitted in accordance with its guidelines.
The performance was confirmed by the pre-completion sound test. It recorded airborne sound levels as high as 60 dB DnT,w+Ctr for the party walls, demonstrating far higher acoustic performance than the minimum of 45 dB required under Approved Document E.
The party floors were found to perform equally well, recording levels as low as 49 dB DnT,w+Ctr for airborne sound and 51 dB L’nT,w for impact sound. The latter also represents a significant improvement compared to the minimum compliance level of 62dB or lower stipulated by the Building Regulations.
As the Fairhaven project demonstrates, early design consultation is key to addressing the potential for flanking noise and reducing the risk of sound test failures further down the line. If flanking is not considered and treated in the floor/ceiling or wall design and the building fails a sound test, the cost and disruption associated with remedial work could be extremely high.
With more than 30 years’ experience of designing and manufacturing acoustic products and systems for dwellings, Hush Acoustics is ideally placed to support architects and developers to achieve acoustic designs that are both Building Regulations compliant and capable of passing sound tests with ease.
The Hush Acoustics range includes more than 30 complete acoustic floor, ceiling and wall systems which have been tested to provide an effective sound insulation treatment for numerous types of construction, including brick and block, timber frame and concrete. The company also offers a wide range of acoustic products including Hush Panel 28, the UK’s most specified acoustic floating floor panel, and Hush Slab Class A1 ‘reaction to fire’ rated sound absorbers for floor and wall cavities.
For technical advice on how to achieve the right acoustic design or find out more about the products and systems available visit www.hushacoustics.co.uk.
Hush Acoustics Ltd
Unit 2, Tinsley Industrial Estate
Shepcote Way
Sheffield
South Yorkshire
S9 1TH
Tel: 0114 551 8685
Fax: 0151 944 1146
EJOT has provided more than 6,000 high performance mechanical anchors for the installation of the electrical services and public address (PA) system in one of the country’s most high profile new road tunnel projects.
Posted in Articles, Building Industry News, Building Products & Structures, Building Services, Building Systems, Case Studies, Civil Engineering, Facility Management & Building Services, Restoration & Refurbishment, Retrofit & Renovation, WallsIn all types of premises – ASSA ABLOY’s new Aperio® P100 Wireless Padlock now provides convenient, connected digital protection.
Posted in Access Control & Door Entry Systems, Architectural Ironmongery, Articles, Building Industry News, Building Products & Structures, Building Services, Doors, Facility Management & Building Services, Innovations & New Products, Restoration & Refurbishment, Retrofit & Renovation, Security and Fire ProtectionLeading specialist supplier IronmongeryDirect has released its latest catalogue featuring 500 new additions to its extensive range.
Posted in Access Control & Door Entry Systems, Air Conditioning, Architectural Ironmongery, Articles, Building Industry News, Building Products & Structures, Building Services, Doors, Heating Systems, Controls and Management, Heating, Ventilation and Air Conditioning - HVAC, Information Technology, Innovations & New Products, Interior Design & Construction, Interiors, Posts, Publications, Restoration & Refurbishment, Retrofit & Renovation, Security and Fire ProtectionAcoustic floor and wall systems designed and supplied by Hush Acoustics have enabled the developer of a new build apartment scheme in Surrey to deliver high quality homes.
Posted in Acoustics, Noise & Vibration Control, Articles, Building Industry News, Building Products & Structures, Building Services, Case Studies, Facility Management & Building Services, Floors, Insulation, Restoration & Refurbishment, Retrofit & Renovation, Walls